夹具订制
AGG可在机械手和模具间提供精i准的中心。
注塑模具内金属嵌件安放时尤其要注意这一点。
夹具AGG...B 安装在EOAT上，钢管 AGG...C 安装在模具上。
一旦机械手向模具靠近，夹具在压力的作用下逐步向钢管靠近，
并与之接触。
AGG21-B 和 AGG30-B 采用的是双动作安全弹簧，确保在压缩空
气 (NC)缺失时设备的正常运行。
AGG19-B 采用的是单动作复位弹簧(NO)。
Gripper for engagement
The AGG is used to provide a precise centering between the robot
and the mould.
This necessary when metal inserts must be p1aced in the
mould, before the p1astic injection.
The gripper AGG…-B is fitted on the EOAT, while the steel bushing
AGG…-C is fitted on the mould.
Once the robot has approached the mould, the gripper is
pressurized, thus it closes and engages the bushing.
AGG21-B and AGG30-B are double-acting with a safety spring to
keep the gripper engaged even without compressed air (NC).
AGG19-B is single-acting with reset spring (NO).
传感器
可以通过一个 3 输出可编程传感器（需另行购买）检查运行位置，该传感器用于检测嵌入右侧颚形钳的磁体位置。
The operating position can be checked by one 3 - outputs programmable sensor (not included), detecting the position of the magnet on the right jaw.
带有 3 个颚式钳的自动定心气动抓持器（TH 系列）
•双动作，带可选弹簧（一般关闭或者一般开启） (3)。
•长行程或者短行程(1)。
•可通过螺丝紧固在前面(2)。
•高i效率的传动装置(1)。
•可选的类磁感传感器。
•FDA-H1 食品级润滑脂.
•Double acting with optional springs (normally closed or normally open) (3).
•Long stroke or short stroke (1).
•Possibility of front fastening with through screws (2).
•High efffciency force transmission (1).
•Optional magnetic or inductive sensors.
•FDA-H1 food-grade grease.
Gimatic拥有五大系列、3000多种产品，分别涉及气动、电动、真空和传感器等，拥有180多项授权，独有的设计可满足客户各种不同的需求。
以上信息由专业从事抓持器工艺特点的吉玛泰克于2025/2/25 17:14:04发布
转载请注明来源：http://szhou.mf1288.com/jmtkzdh-2843988966.html
